PRODUCT DESCRIPTION

Applying the Cuff

Remove all watches, jewellery, etc. prior to attaching the wrist monitor. Clothing sleeves should be rolled up and the cuff should be wrapped on bare skin for correct measurements.

Apply cuff to left wrist with palm facing up as O.

Make sure the edge of the cuffis about 1 cm from the palm as .

In order to ensure accurate measurements, fasten the velcro strap securely around your wrist so there is no extra space between the cuff and the wrist as . If the cuff is not wrapped tight enough, the measurement values may be false.

If your physician has diagnosed you with poor circulation on your left arm, carefully place the cuff around your right wrist as shown in.

Correct Measuring Posture

Place your elbow on a table so that the cuffis at the same level as your heart as .

Note: Your heart is located slightly below your armpit a bit to the left of the middle of your chest. Relax your entire body, especially the area between your elbow and fingers.

If the cuff is not at the same level as your heart or if you can not keep your arm completely still throughout the reading, use a soft object such as a folded towel to support your arm as 6. Do not allow hard objects to come in contact with the wrist cuff.

Turn your palm upwards.

Sit upright in a chair, and take 5-6 deep breaths. Avoid leaning back while the measurement is being taken as.

Press the User-Switching key to select memory zone 1 or memory zone 2 or guest mode.

Place the cuff on the wrist. Press the ON/OFF/START key. All digits will light up, checking the display functions. The checking procedure will be completed in 2 seconds.

After all symbols appear, the display will show a blinking "O". The monitor is ready to measure and will automatically inflate the cuff to start measurement.

When the measurement is completed, the cuff will exhaust the pressure inside. Systolic pressure, diastolic pressure and pulse will be shown simultaneously on the LCD screen with the date and time appearing on alternating manner in every 4 second interval. The measurement is then automatically stored into the memory zone.

This monitor will re-inflate automatically to approximately 220 mmHg if the system detects that your body needs more pressure to measure your blood pressure.

Note: 

1. This monitor automatically switches off approximately 1 minute after last key operation

2. To interrupt the measurement, simply press ON/OFF/START key or Memory key; the cuff will deflate immediately.